URD Throttle Body Adapter, 70 to 76mm 2010+ FJ and 4Runner V6

This CNC billet machined adapter plate will allow you to install a larger throttle valve on your 2010 and later FJ Crusier and 4Runner V6

It fits the 1GR-FE engines with the DUAL VVTi (2010+ FJ Crusier and 4Runner V6) and allows you to move from the stock 70mm throttle and upgrade it to the 76mm throttle valve found on the later dual VVTi engines found in the 2005+ 2UZ-FE 4.7L V8 and 2007+ 3UR-FE 5.7L V8. Throttle valve from a 2006 Sequoia does not fit.

This adapter is used to install the much larger (76mm) throttle valve from the larger Toyota engines to your 4.0L V6.

It is a simple bolt on and plug in installation.  You simple need to put a thing layer of RTV silicone on the back side fo the new throttle valve to seal it and adapt it to your current intake system.

Installation Note:
Idle will run high on some vehicles but will readjust once the ECU learns to properly control the idle (this can take up to 800 miles on some vehicles).  The stock air filter box may not be able to fit the larger diameter of the 76mm throttle valve.  Aftermarket intakes my require a larger silicone boot to fit, 3-3.25″.